Cmos Clear (Jp1); Dram Installation; Ddr Sdram (Dimm 1 And Dimm 2) - Advantech AIMB-330F User Manual

When the CPU is installed, the lever should snap into place at the side of
the socket.
Note:

2.5.2 CMOS clear (JP1)

Warning!

2.6 DRAM installation

There are two on-board 186-pin DDR DIMM sockets.

2.6.1 DDR SDRAM (DIMM 1 and DIMM 2)

You can install one DDR SDRAM (up to 1 GB) or two 186-pin DIMM
(up to 2 GB DRAM) in the DIMM sockets.
Caution!
AIMB-330F User's Manual
To remove a CPU, pull the lever out to the side a
little and raise it
To avoid damaging the computer, always unplug
the power cord to turnoff the power supply
before setting "Clear CMOS." Use a pencil or a
tool to press the tactile-switch.
When installing DIMM, make sure the module is
oriented properly. Do not use excess force during
installation.
16