Advantech SIMB-U01 User Manual page 57

Onboard FDC Controller
When enabled, this field allows you to connect your floppy disk drives to the
onboard floppy disk drive connector instead of a separate controller card. If you
want to use a different controller card to connect the floppy disk drives, set this
field to Disabled.
Onboard Serial Port
The settings are "3F8/IRQ4", "2F8/IRQ3", "3E8/IRQ4", "2E8/IRQ3", "Disabled"
and "Auto" for the on-board serial connector.
Onboard Parallel Port
This field sets the address of the on-board parallel port connector. You can
select "378/IRQ7", "278/IRQ5", "3BC/IRQ7", or "Disabled". If you install an I/O
card with a parallel port, make sure there is no conflict in the address assign-
ments. The single board computer can support up to three parallel ports.
Parallel Port Mode
This field allows you to set the operation mode of the parallel port. The setting
"Normal" allows normal speed operation, but in one direction only. "EPP"allows
bidirectional parallel port operation at maximum speed. "ECP" allows the paral-
lel port to operate in bidirectional mode and at a speed faster than the maximum
data transfer rate. "ECP + EPP" allows normal speed operation in a two-way
mode.
EPP Mode Select
This field allows you to select EPP port type 1.7 or 1.9. The choices are
"EPP1.9" and "EPP1.7".
ECP Mode Use DMA
This selection is available only if you select "ECP" or "ECP + EPP" in the Paral-
lel Port Mode field. In ECP Mode, you can select DMA channel 1 or DMA chan-
nel 3. Leave this field on the default setting.
Power After PWR-Fail
Use this to set up the system after power failure. The "Off" setting keeps the
system powered off after power failure, the "On" setting boots up the system
after failure, and the "Former-Sts" returns the system to the status before power
failure.
3.2.4.4 JMicron 36X ATA Controller
The options: Enabled, Disabled.
3.2.4.5 Onboard LAN Boot ROM
The options: Enabled, Disabled.
3.2.4.6 Watch Dog Timer Selection
The options: 0 ~ 255.
51 SIMB-U01 User Manual