Configuring The Performance Management Module - Zte ZXR10 5900E Series Configuration Manual

3.7.2 Configuring the Performance Management Module

To configure the performance management module on the ZXR10 5900E, perform the
following steps:
Step Command
1
ZXR10(config)#
2
ZXR10#
3
ZXR10#
Enter configuration commands,
one per line. End with CTRL/Z.
ZXR10(config)#
statistics)#
4
ZXR10(config-intf-statistics)#
ak_value {disable|enable}{<interface-name>|default}
5
ZXR10(config-intf-statistics)#
ak_value_clear [<interface-name>]
6
ZXR10(config-intf-statistics)#
7
ZXR10(config)#
<periodreport>[checkPtType]
For a description of the parameter in Steps 2 and 6, refer to the following table:
Parameter
<interface-name>
For a description of the parameter in Step 4, refer to the following table:
Parameter
<interface-name>
default
For a description of the parameter in Step 7, refer to the following table:
Parameter
<periodreport>
[checkPtType]
SJ-20150114102049-002|2015-01-15 (R1.0)
end
clear statistics interface [<interface-name>]
conf t
intf-statistics
ZXR10(config-intf-
performance update-interval
Description
Interface name.
Description
Interface name.
All interfaces.
Description
Sampling interval.
Type of the check point.
3-47
Chapter 3 Network Management
Function
Enters privileged configuration mode.
Clears the performance value
accumulated on the specified
interface.
Enters interface statistics configuration
mode.
Controls the one-minute peak-value
one_minute_pe
on the specified Ethernet interface or
all interfaces.
Resets the one-minute peak-value on
one_minute_pe
the specified Ethernet interface or all
interfaces.
Enters global configuration mode.
exit
Specifies the time interval (in seconds)
for the
PMA, default: 10.
ZTE Proprietary and Confidential
PMS to sample data on the