Zte ZXR10 5900E Series Configuration Manual page 59

Now running in RAM - U-Boot at: 7ff15000
NAND:
512 MiB
FPU not initialized
Modules Detected:
Not Marvell PHY id1 ffff id2 ffff
egiga0, egiga1, egiga2, egiga3
yaffs: Mounting /flash/
Bad block table found at page 262080, version 0x01
Bad block table found at page 262016, version 0x01
yaffs: restored from checkpoint
Hit any key to stop auto-boot:
[boot]: c
'.' = clear field;
Boot Location [0:Net,1:Flash,2:USB]: 0 1
Client IP
Netmask
Server IP
Gateway IP
FTP User
FTP Password
Bootfile
Enable Password
Save parameter to nvram success.
[boot]:
[boot]: b
Boot Location [0:Net,1:Flash,2:USB]: 1
Client IP
Netmask
Server IP
Gateway IP
FTP User
FTP Password
Bootfile
Enable Password
3. After the system is started, enter the OAM man-machine interaction interface and
run show version to see whether the displayed version number is consistent with
the version number of the newly released version set file. If yes, it indicates
that the upgrade succeeded; otherwise, it indicates that the upgrade failed. The
command and method are the same as those in "Upgrading Version in Network
Mode".
SJ-20150114102049-002|2015-01-15 (R1.0)
<<>>flashIdx=12,---fo1:1144, fo2:88--
'-' = go to previous field;
2-23
Chapter 2 System Management
0
'^' = quit
: 168.0.0.51
: 255.255.255.0
: 168.0.0.178
: 168.0.0.1
: 59
:
: HMPU.set
:
: 168.0.0.51
: 255.255.255.0
: 168.0.0.178
: 168.0.0.1
: 59
:
: HMPU.set
ZTE Proprietary and Confidential