Rikon Power Tools 10-326 Operator's Manual page 20

ADJUSTING THE FENCE TO THE TABLE
Check that the fence is lying flat or parallel to the table
surface. The gap between the table and the bottom
of the fence should be equal along the whole length
of the fence. The rear, bottom of the fence includes a
Nylon Plate (#23F) that helps in sliding the fence over
the table. A small gap between the fence and table
results from this plate. Fig. 34.
If there is a sizeable gap, refer to page 12 for the
mounting and re-positioning of the front fence rail.
ADJUSTING THE FENCE ON THE CARRIER
The fence can be changed from a vertical position to
a horizontal position, or from its mounting on the left
side of the blade to the right with simple adjustments
of the carrier's handles and hardware.
To change the fence from vertical to horizontal:
1. Loosen the side Handle (#7F, Fig. 35, A) which
holds the rip fence again the Fence Carrier (#9F, B).
2. Slide the fence forward to remove it from the
carrier's Sliding Block (#11F, Fig. 35, C).
3. Turn the fence down to its horizontal position and
slide it back onto the carrier. The bottom of the fence
is slotted to mount on the sliding block, and position
itself on the small, raised key on the side of the
carrier. Fig. 36, D.
4. Once in place, retighten the side handle to secure
the fence in position on the carrier.
5. Check the fence for drift, and make corrections if
needed per instructions on page 19.
To change the fence from the left side of the
carrier to the right side for using the rip fence to
the right of the blade:
1. Loosen the side Handle (#7F, Fig. 35, A) which
holds the rip fence again the Fence Carrier (#9F, B).
2. Slide the fence forward to remove it from the
carrier's Sliding Block (#11F, C). Move the carrier on
the front rail to the right side of the table and blade.
3. Fully unscrew the side handle from the sliding
block and reassemble the parts on the opposite, left
CONTINUED ON PAGE 21
ADJUSTMENTS
A
SIDE HANDLE AND SLIDING BLOCK
MOVED TO OPPOSITE SIDES
20
FIGURE 34
C
B
FIGURE 35
FIGURE 36
ON CARRIER
FIGURE 37