Rikon Power Tools 10-326 Operator's Manual page 10

LINK TO 10-326
ASSEMBLY VIDEO
1. Check contents of Cabinet Stand against the parts list, and lay out parts for quick reference.
2. Install the Left Side Panel (item # 6) onto the Base Panel (15) with two Hex Socket Screws (14).
3. Install the Right Side Panel (11) on to the Base Panel (15) with two Hex Socket Screws (14).
4. Add two Hex Bolts with Flanges (14) to the front lower edges of each side panel, and leave them loose.
Onto these two bolts, attach a connecting Beam (13) and fasten in place.
5. Install the Handle onto the right side panel with Hex Socket Cap Screw and Nut (9).
6. Add three Hex Bolts with Flanges (14) to the rear edges of both the Left and Right Panels, and leave them
loose. Onto these six bolts slide on the Back Side Panel (8). Fasten only the top and bottom bolts, leaving
the middle two bolts loose. These will be used for attaching the shelf in step 7.
7. Install a Big Washer (7) and Hex Bolt with Flange (14) to the middle holes in the front edges of both the Left
and Right Panels. Onto these four, loose middle bolts, install the Shelf and tighten the bolts to secure the
shelf in place.
8. Add two Hex Bolts with Flanges (14) to the front top edges of each side panel, and leave them loose. Onto
these two bolts, attach the last connecting Beam (13) and fasten in place. Make sure all nuts are secure.
9. Install the Door Assembly (4) on to the left side panel by sliding its hinges onto the hinge pins.
10. Onto the right edge of the door, install the handle's locking Screw (1), Bushing (2) and Nut (3).
11. Mount the Bandsaw to the assembled Cabinet Stand with four Screws (5). This can be done in two ways;
A) With assistance, lift the bandsaw and carefully position it in place on top of the stand. B) If alone, lay
the bandsaw down on its column onto 4x4 wood blocks, and lay the stand also on its side on blocks to
match the bandsaw height. This will allow room to install the screws. Then tilt the saw up when done.
STAND ASSEMBLY
ITEM # DESCRIPTION
1 Screw M6x16
2 Bushing
3 Self-locking nut M6
4 Door assembly
5 Hex socket screw M6x50
6 Left side panel
7 Big washer
8 Back side panel
QTY ITEM #
1 9
1 10
2 11
1 12
4 13
1 14
2 15
1
10
DESCRIPTION
Hex socket cap screw M6x20 1
Handle
Right side panel
Shelf
Beam
Hex bolt with flange M8x20
Base panel
QTY
1
1
1
2
16
1