Viewing The Battery Level; Compatible Devices; Charging External Devices - Silvercrest SLS 2200 B1 User Manual And Service Information

SilverCrest SLS 2200 B1

Viewing the battery level

Press the ON/OFF pushbutton (5) briefly to display the battery level for a few
seconds. The Battery capacity LEDs (4) indicate the battery level as a
percentage (25%, 50%, 75% and 100%).

Compatible devices

The Solar Power Bank can be used to charge external devices with a max.
charging current of 1A.
If the charging current of your connected device exceeds 1A, the Solar Power
Bank will automatically power off after you turn it on with the ON/OFF
pushbutton (5). In this case, double-check the external device compatibility by
reading its technical specifications (operating instructions).

Charging external devices

Connect the charger cable of your external device to the OUT socket (6) of the
Solar Power Bank and to your external device.
Now press the ON/OFF pushbutton (5) briefly to start the charging process.
Then the 5V LED (3) lights while the connected device is being charged. When
your external device is fully charged, the Solar Power Bank switches off. To
cancel the charging process at any time, simply disconnect the external device.
If your external device is not fully charged but the 5V LED (3) goes out during
charging, the built-in battery of your Solar Power Bank is empty. You will need
to recharge your Solar Power Bank in order to charge external devices.
Recharging the built-in battery of your Solar Power Bank and an external
device at the same time is only possible in solar mode. Recharging the Solar
Power Bank and an external device at the same time via the USB IN port (7) is
not possible.
English - 15