Checking The Battery Status; Charging Mobile Devices With The Power Bank - Silvercrest TPB 10000 A1 Operation And Safety Notes

WARNING! Do not connect any device to be charged to
power bank as long as the power bank is charging. Remove the
charging cable from the power bank when it is fully charged.

Checking the battery status

You can check the battery status via the LED indicator
power bank 3
Briefly press the ON / OFF button
7 shows the approximate charge status of the internal
battery capacity level for approx. 30 seconds.
Charging mobile devices with the
power bank
You can charge up to two devices at the same time using the
power bank
3
sum of the output current may not exceed 3 A.
To charge your QuickCharge 3.0 enabled device, connect
the USB Type A plug of USB cable
Type A to USB Type C charging cable of the device to
be charged to the USB type A output
QuickCharge 3.0. Then connect the USB Type C plug of the
USB cable
be charged. The charging process will start automatically.
When a QuickCharge enabled device is charged at the
Type A port, the fourth LED of the battery capacity indicator
lights up green.
NOTE: You could also charge your conventional USB
devices from the USB Type A output port
using the included USB cable
USB cable (not included).
at anytime.
. If all outputs are used at the same time, the
4 to the USB Type C input port of the device to
6 . The LED indicator
4 or the original USB
which supports
2
2 of the power bank
or a USB Type A to micro
4
of the
7
GB/IE 33