Board Configuration; 4-Wire Wireline Interface Board; 4-Wire Euro Wireline Interface Board; Cln1203 Wireline Interface Board Jumper Settings - Motorola MTR2000 Installation And Operation Manual

3

BOARD CONFIGURATION

Most station configuration parameters are altered through the Radio Service Software (RSS) with the exception of
some parameters for the following boards, which are configured through jumpers:
• 4-Wire Wireline Interface Board (CLN1203),
• 4-Wire Euro Wireline Interface Board (CLN1204),
• Auxiliary I/O Board(CLN1206).

4-Wire Wireline Interface Board

.
Tone Remote Control
2-wire/4-wire configurations
Figure 6.

4-Wire Euro Wireline Interface Board

68P81096E37-N
06/28/05
Model CLN1203 WIB supports tone control of the station. CLN1203 pro-
vides a fixed impedance of 600Ω to the wireline. Figure 6 shows the jump-
er locations for tone control.
P10, P12, P14, P16,
P11 P13 P15 P17
out

CLN1203 Wireline Interface Board Jumper Settings

Figure 7 shows the correct settings of impedance matching jumpers for the
model CLN1204 WIB, as determined by the country in which the station is
being operated. Incorrect jumper settings may violate local telecommuni-
cations authority regulations and place the equipment in an unapproved
status. Some countries also specify a maximum allowed line input level.
Refer to the RSS Online Help, under Line Level.
P2
T1
P11 P10
C74
P15 P14
C84
P13 P12
P17
P16
T2
P6
Installation
C15
21