Installing Slide Rail Assembly In A Non-Motorola Cabinet - Motorola MTR2000 Installation And Operation Manual

On a bench-top, working
on one side of the slide rail
assembly at a time...
Note
Working in the cabinet...
68P81096E37-N
06/28/05

Installing Slide Rail Assembly in a Non-Motorola Cabinet

Referring to Figure 5, perform the following procedure to install slide rail
option X346AB.
1. Remove the Inner-Slide Rail from the slide assembly (left and right)
by depressing the Slide Locking Latch and sliding the Inner-Slide Rail
out from the slide assembly.
2. Install the Inner-Slide Rail (left) on the Power Supply side by:
- removing the 2 bottom screws from the station power supply
EMI cover, and
- installing the Inner-Slide Rail (left) with the supplied screws.
3. Install the Inner-Slide Rail (right) on the PA side using the holes in the
PA casing.
4. Attach each Outer-Slide Rail to the cabinet Brackets with supplied
screws. Only use the lower slot of each bracket. Leave the screws
loose; they will tightened when the brackets are mounted in the cab-
inet (step 7).
The left and right Cabinet Bracket sets are identical.
The Locking Tab of each Outer-Slide Rail must face towards the rear
of the cabinet.
5. Install a cage nut in line with clearance hole in Threaded Strip prior
to fitting the Front Bracket to the front cabinet rail.
This nut is required for mounting the station (in step 9).
The cage nuts are provided with the cabinet.
6. Fit the Short Bracket and Long Bracket (with attached Outer-Slide
Rail) to the Front and Rear Cabinet Rails using the Bracket Mounting
Screws and Threaded Strips.
7. Tighten the Outer-Slide Rail hardware after positioning the Outer-
Slide Rail front side in line with the inner surface of the Front Cabinet
Rails.
8. Slide the station (with an Inner-Slide Rails mounted on each side) into
the Outer-Slide Rails in the cabinet; an audible snap is heard.
Continue sliding the station in until the station is fully seated.
9. Secure the station to the Front Cabinet Rails with the supplied Station
Mounting Screws.
Installation
19