Installation
FailSoft
FS
PA Keyed
FS
CAUTION
46
This FailSoft LED indicates the following:
LED
LED Color
Yellow
This LED is lit when no activity is detected on the transmit data signal
from the trunking central controller; the station is in Failsoft mode. This
condition usually indicates a failed link to the trunking central controller.
This PA Keyed LED indicates the following:
LED
LED Color
Green
Green
Listening For Audible Alarms
With a Service Speaker connected to the station (see Station Operation,
Service Connections), any active audible alarms can be heard.
Alarm
AC Fail
PA Fail
The audible alarms are repeated every 10 seconds. If more than one alarm
is active, they are offset by 2 seconds.
Exercising Radio Operation
Operation of the station radio can be verified by exercising the radio's two-
way operation. This may be carried out when an external speaker and mi-
crophone are connected to the Station Control Module (SCM).
The kit # for the speaker is HSN1000. The external speaker requires an
adaptor cable, part # 0185180U01.
!
Using a speaker other than the recommended HSN1000 may result in
the station blowing a fuse.
The kit number for the microphone is GMN6147B.
LED State
Flashing
station is in the Trunking system
Failsoft mode.
LED State
On
PA is keyed.
Flashing
PA is keyed, but operating with
power cutback.
Sound
a single short beep
a station configured with DC-
revert has detected an AC power
failure.
two short beeps
the station has been keyed, and the
Power Amplifier has failed.
Indicates that the ...
Indicates that the ...
Indicates that ...
68P81096E37-N
06/28/05