Mechanical Installation; Unpacking Equipment; Introduction; Unpacking Stations - Motorola MTR2000 Installation And Operation Manual

Base station, repeater and receiver for analog conventional, and trunking systems
Hide thumbs Also See for MTR2000:
Table of Contents

Advertisement

Installation
2

MECHANICAL INSTALLATION

This section describes the procedures to unpack and mechanically install the station equipment. A variety of
mounting methods are possible, depending on whether a cabinet or rack (if any) has been selected to house the
station(s). Installation procedures are provided for each of the cabinet and rack types, as well as the slide rail.
STOP
IMPORTANT

Unpacking Equipment

STOP
IMPORTANT
STOP
WARNING
12
Be sure to observe proper electrostatic discharge precautions if modules
must be removed from the station.

Introduction

Station equipment packing methods vary depending upon the type of op-
tional rack or cabinet selected by the customer. Unpacking procedures for
these various methods are provided in the following paragraphs.
The equipment must be immediately inspected for damage after un-
packing, and a report of the extent of any damage made to the transpor-
tation company and to Motorola.

Unpacking Stations

The station is shipped in a carton, cushioned by four plastic inserts at the
corners of the carton.
Improper handling of the station may cause personal injury or damage
to the station. DO NOT pick up the station by holding the Preselector
(if so equipped). Use the handles on the front of the station, or the Pow-
er Supply and Power Amplifier casings when picking up the station.
Front Panel – Removal and Replacement
Remove station front panel by inserting a small flat-blade screwdriver into
one of two access holes at either end of the panel and, by carefully moving
the handle of the screwdriver away from the center, release the front panel
locking clip from the chassis and pull away the panel
Replace station front panel by inserting one of the front panel locking clips
into corresponding latch on the station housing, and carefully pressing the
panel on the opposite side until the second locking clip snaps into place.
.
68P81096E37-N
06/28/05

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents