Verifying Proper Operation; Front Panel Leds - Motorola MTR2000 Installation And Operation Manual

Base station, repeater and receiver for analog conventional, and trunking systems
Hide thumbs Also See for MTR2000:
Table of Contents

Advertisement

Installation

Verifying Proper Operation

FS
Station Status
FS
44
Operation of the station can be verified by:
observing the state of the 4 LEDs located on the front panel
listening to audible alarms, and
exercising radio operation.
Some station components can become extremely hot during station op-
eration. Turn off all power to the station, and wait until sufficiently cool
before touching the station.

Front Panel LEDs

After turning the station power ON (or after a station reset), the 4 LEDs on
the station front panel:
1.
Are all lit for about 3 seconds to indicate that they are functional.
The Station Status LED appears yellow since both the red and green
LEDs of this bicolor indicator are lit at the same time.
2.
All go off for about 15 seconds.
3.
All stay off except for the Station Status LED which goes red for
about 6 seconds.
4.
Now indicate operational status of the station. The 4 LEDs indicate:
-
PA Keyed LED; green – station PA is keyed.
-
FailSoft LED; yellow – (if set up for trunking) station is not be-
ing controlled from the trunking central controller.
-
Rx Active LED; green – station is unsquelched.
FS
-
Station Status LED; red/green – operational status of station.
This two-color Station Status LED (i.e., red or green) indicates the follow-
ing:
LED
LED Color
Off
Red
Red
Green
Red/Green
Green
LED State
Off
5V power is not present
On
Station is Not Operational –
major failure
Flashing
Station is Operational but Not
Fully Functional – minor failure
On
Station is Operating Normally
Alternately Flashing
Station is in Boot Mode
Flashing
Station is in Service Mode
Indicates that the...
68P81096E37-N
06/28/05

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents