Start-Up; What This Chapter Contains; Safety; Introduction - ABB MotiFlex e180 Application Manual

Ethercat

Hide thumbs Also See for MotiFlex e180:

Table of Contents

Start-up

This chapter describes software installation and the start-up procedure of the drive.

WARNING! Read the

before performing any maintenance on the equipment. Ignoring the safety

instructions can cause injury or death.

Before powering the MotiFlex e180 you must connect it to the PC using an Ethernet

cable and install the Mint WorkBench software on the PC. This includes a number of

applications and utilities to allow you to configure, tune and program the

MotiFlex e180. Mint WorkBench and other utilities can be downloaded from the

SupportMe pages of www.abbmotion.com.

Connect a CAT5e or CAT 6 Ethernet cable between the PC and the MotiFlex e180 E3

Ethernet port on the front panel. Do not connect the cable to the E1 or E2 ports on the

top of the drive.

NOTE! You cannot connect an ordinary office PC to the MotiFlex e180 without

first altering the PC's Ethernet adapter configuration. See

Ethernet adapter

on page 22.

Safety

instructions on the first pages of this manual

Start-up 21

Configure the PC

Table of Contents

Show Quick Links

Table of Contents