Table of Contents
Advertisement
Symptom
Part of the job on the
platform side is missing
Part of the job is missing
along the vertical edge of
the work area
The job drops into the
liquid material vat
Points to check
Are there supports
attached around the
missing part?
Is the object contained
within the work area?
Is the liquid material
vat dirty or cloudy?
Has the initial height
of the printing platform
been adjusted?
Is the object's center
of gravity heavily
skewed?
Is the density of the
supports low?
Action
Increase the number of
supports.
Areas of the object that extend
outside the work area will not
be printed. Check that the file
is contained within the work
area.
If the bottom of the liquid
material vat is cloudy, set the
non-cloudy part toward the
back of the machine.
If the liquid material vat is
dirty, wash it.
Alternately, replace the liquid
material vat with a new one.
Adjust the initial printing height
to the optimum height.
Change the shape of the
object so that the center of
gravity is in the center of the
job.
Increase the number of
supports.
Increase the number of
supports.
Chapter 4 Appendix
Troubleshooting
Refer to
P.46
P.25
Quick Denta
Help
P.53
P.20
—
P.46
Quick Denta
Help
P.41
Quick Denta
Help
57
Advertisement
Table of Contents
