Table of Contents
Advertisement
Troubleshooting
The Machine Doesn't Work
Symptom
The machine does not
output the print file
Printing Fails
Symptom
Part of the job on the
liquid material vat side is
missing
56
Chapter 4 Appendix
Points to check
Is the machine turned
on?
Has the connector
cable come loose?
Does the computer
have enough disk
space?
Points to check
Is the liquid material
vat dirty or cloudy?
Is there enough resin
in the liquid material
vat?
Is there a problem
with the angle of the
machine?
Action
Turn on the machine.
Connect the cable.
The computer was unable to
obtain the disk space required
to output the file.
Increase the amount of
free disk space by deleting
unnecessary files, etc.
Action
If the bottom of the liquid
material vat is cloudy, set the
non-cloudy part toward the
back of the machine.
If the liquid material vat is dirty,
wash it.
Alternately, replace the liquid
material vat with a new one.
Check the "Estimated job
volume" displayed in Quick
Denta before printing and make
sure there is enough resin in
the liquid material vat.
Printing will also not be possible
if there is not enough resin in
the printing part of the liquid
material vat (toward the rear of
the liquid material vat). Make
sure there is enough resin in
the liquid material vat so that
the rear of the vat does not
become empty while printing.
It is necessary to position the
machine on an angle so that
the remaining resin collects in
the printing part (the back of
the liquid material vat) even as
the amount of resin decreases
during printing. For information
on how to adjust the machine
tilt, refer to the "Setup Guide."
Refer to
P.10
Setup Guide
—
Refer to
P.53
P.54
P.28
Setup Guide
Advertisement
Table of Contents
