Compressed Air System - Grizzly T27338 Owner's Manual

Compressed Air
System
The Model T27338 is designed to be oper-
ated at 70-115 PSI using clean, dry, regu-
lated, compressed air. DO NOT exceed
the 115 PSI maximum operating pres-
sure for your model. Before using, regu-
late the air pressure on your air compres-
sor to 70 psi.
An in-line filter/lubricator/regulator unit,
depicted in Figure 3, can be installed and
should be located as close to the nailer as
possible.
The filter/lubricator/regulator unit will
protect your tool from damaging water
build-up, allow you to adjust and maintain
constant air pressure to your tool, and
save you the inconvenience of having to
manually lubricate your tool every time
you use it.
Check the current Grizzly catalog for avail-
ability of this unit. If you plan on install-
ing a filter/lubricator/regulator unit in your
compressed air system, always follow the
connection instructions that come with
the unit.
Quick
Connector
Your
Tool
Quick
Coupler
Figure 3. Typical filter/lubricator/regulator installation order.
Model T27338 (Mfd. Since 01/15)
Quick
Connector
Quick
Air Hose
Coupler
Exceeding maximum
operating pressure may cause nailer
to explode, blowing metal fragments
in all directions. To protect yourself
and bystanders from serious personal
injury, DO NOT allow your air com-
pressor to exceed the recommend-
ed pressure when connected to this
nailer!
Lubricator
Regulator
Filter
permissible
Air
Compressor
-7
-