Table of Contents
Advertisement
Assembly
To assemble flooring nailer:
1. Place handle against flooring nailer
body, as shown in Figure 4, making
sure it is centered from top to bottom.
Handle
Figure 4. Handle placed against flooring
nailer.
2. Slide an L-bolt into mounting hole and
slot in handle and secure with (2) 8mm
flat washers and (2) M8-1.25 lock nuts,
as shown in Figure 5.
x 2
Figure 5. L-Bolt installed.
Tip: Place thread locking compound on
lock nuts before threading onto L-bolts,
to prevent nuts from loosening.
-8
-
3. Repeat Step 2 to install remaining
Figure 6. Handle installed onto nailer.
L-Bolt
L-bolt. The handle should appear like
the one in Figure 6 when installed.
Model T27338 (Mfd. Since 01/15)
Advertisement
Table of Contents
