Grizzly T27338 Owner's Manual page 21

5. Twist off head cap shown in Figure 28.
6. Remove (4) cap screws from cylin-
der cover shown in Figure 28. Slide
cylinder cover and rubber gasket off
plunger.
Cylinder
Head Cap
(1 of 4)
Figure 28. Cylinder cover location.
7. Unscrew (3) cap screws and remove
plunger (see Figure 29).
Plunger
Figure 29. Plunger location.
8. Remove snap ring and split ring from
top of piston assembly (see Figure 30).
Snap Ring
Figure 30. Split ring and snap ring
location.
Model T27338 (Mfd. Since 01/15)
Cover
(1 of 3)
Split Ring
9. Push driver up to remove plung-
er seat and compression spring
(see Figure 31).
Plunger Seat
Figure 31. Plunger seat and compression
spring.
10. Grab onto driver and pull piston assem-
bly out from bottom.
11. Apply thin film of nailer lubricating oil on
O-rings of new piston assembly.
Piston
Assembly
Figure 32. Piston and driver.
12. Re-assemble nailer in reverse order.
Compression
Spring
O-Rings
-19
-