Grizzly T27338 Owner's Manual page 13

3. Open magazine cover and slide strip of
nails or staples pointed-end down into
magazine, as shown in Figures 8–9.
L-Cleat Nails
Figure 8. Loading L-cleat nails.
Staples
Figure 9. Loading staples.
4. Push lock button and allow pusher
to slide nails/staples toward nose of
nailer.
Model T27338 (Mfd. Since 01/15)
Magazine Cover
Magazine
Magazine Cover
Magazine
Changing Guide Plate
The Model T27338 comes with a pre-
installed ⁄ " guide plate and a
25
32
un-installed guide plate. The
plate is used for ⁄ " or
3
4
ing; the ⁄ " guide plate is used for
1
2
hardwood flooring.
Tool Needed
Hex Wrench 4mm ..................................... 1
To change guide plate:
1. DISCONNECT NAILER FROM AIR
SOURCE!
2. Pull magazine pusher back (see
Figure 10), secure it with lock button,
remove any nails/staples from maga-
zine, then unlock pusher and slide it
forward.
3. Place scrap wood under nose of nailer
and hit head cap (see Figure 10) to
make sure magazine is empty.
Head
Cap
Figure 10. Location of head cap.
⁄
1
⁄ " guide
25
32
⁄ " hardwood floor-
25
32
⁄ " or ⁄
1 5
2
Qty
Lock Button
Magazine
Pusher
-11
"
2
"
8
-