Eas Deactivation Set-Up - Metrologic MS2020 Stratos series Service Manual

STRATOS SYSTEM AVAILABLE CONFIGURATION / SET-UP

EAS Deactivation Set-Up

SW1 and SW2 are the switch banks inside the CheckPoint Device that set the deactivation
range. The following is a list of CheckPoint recommended switch bank settings.
Base Model
MS2020
MS2021
MS2022
All models have a connector ( marked EAS In ) on the bottom of the scanner/scale. Metrologic
provides an EAS cable (
Checkpoint Device.
The following figure shows the location of the EAS deactivation area for Stratos. It is important
to pass the entire tag through this area to deactivate the security tag.
©2004 Metrologic Instruments, Inc. All rights reserved
CheckPoint Recommended Switch Bank
SW1 & SW2 switches 1 and 6 set to ON
SW1 & SW2 switches 1 and 6 set to ON
SW1 & SW2 switches 1 and 6 set to ON
52-52511A) for connection between the scanner/scale and the
MLPN
EAS Cable Connection (Bottom of Stratos)
EAS Deactivation Area
71
Settings
MS2020 Stratos Service Manual