Horizontal Scan Window Replacement (Sapphire Window Only!); Horizontal Scan Window Replacement (Diamonex Window Only!) - Metrologic MS2020 Stratos series Service Manual

Hide thumbs Also See for MS2020 Stratos series:

Table of Contents

SERVICING AND MAINTENANCE PROCEDURES

Horizontal Scan Window Replacement

(Sapphire Window ONLY!)

1. Lift platter straight up to remove.

2. Position the replacement platter in the

support channel and over the alignment

guide. The MS2020 scale unit does not

have a support channel or alignment

guide. The platter simply sits over the

scale arms.

Horizontal Scan Window Replacement

(Diamonex Window ONLY!)

1. Lift platter straight up to remove from

Stratos Chassis.

2. Remove two philips head screws on

window side of the platter, allowing the

steel reinforcement bar to come free.

(Shown in Figure to the right)

3. Carefully

remove

Logo 'BREAK' brace from platter by

pulling straight out, away from the

platter itself. (See Figure to the right)

4. Diamonex glass can now be removed

by carefully push up on glass from

underside of platter, along rear edge

shown in Figure below.

5. Carefully install new glass in the reverse

order as glass was removed. Ensure

that when glass is installed, the 'THIS

SIDE UP' message etched into glass is

readable. (See Figure below & to the

right)

plastic

Metrologic

STEEL REINFORCEMENT BAR

MS2020 Stratos Service Manual

Table of Contents

Troubleshooting