STRATOS SYSTEM AVAILABLE CONFIGURATION / SET-UP
OCIA Configuration
Initializing Scanner into OCIA mode:
1. With only Stratos Scanner Power on and Host device Power off.
2. Scan 'Load OCIA Defaults' barcode below. (This will set-up internally with software, the
proper settings for OCIA system configuration.)
3. Now apply power to Host Device.
Load OCIA Defaults
9
9
9
9
9
©2004 Metrologic Instruments, Inc. All rights reserved
3
68
For additional communication options for
OCIA interfaces refer to the MetroSelect
Programming Guide (
MLPN
MS2020 Stratos Service Manual
00-02407).