Cable Management System; Console Port; Rj45 Port Pinouts - Cisco ASR 5500 Installation Manual

Cable Management System

Cable Management System

If you have equipped your ASR 5500 chassis and MIO/UMIO cards with the Cable Management System,
refer to the Routing and Securing Network Cables section of the Cable Management System Installation
appendix for additional information.

Console Port

The Console port (logical Port 3) is an RJ45 RS-232 interface on an MIO or UMIO card that provides access
to the command line interface (CLI). The interface communicates at 9600 to 115200 bps; the default is 115,200
bps.
Important

RJ45 Port Pinouts

Table 9: Console Port RJ45 Serial Pinout
Pin
1
2
3
4
5
6
7
8
Important
ASR 5500 Installation Guide
62
A connection to the Console port is required if you wish to view boot messages whenever the ASR 5500
chassis is powered up or rebooted. Only the Console port on the Master MIO or UMIO supports logs and
CLI sessions. The Console port on the Standby MIO or UMIO is inactive.
Signal Description
Not connected
Not connected
Receive Data (RX)
Signal Ground (SGND)
Not connected
Transmit Data (TX)
Not connected
Not connected
Hardware flow control is not supported and must be disabled on the connected equipment.
Signal Type Pinout
—
—
Input
Not applicable
—
Output
—
—
MIO Port Cabling