Cisco ASR 5500 Installation Manual page 174

Installing the Cable Management Tray
Step 7
Verify that the tray can be swung upward into its closed position. Test the latches by clipping them to the posts on the
swing arms. You may need to apply slight inward pressure on the latches so they will clear the swing arms and rest on
the posts. See the figure below.
Figure 33: Testing Latches on the Cable Management Tray
1 Cable management tray
3 Latch
To lower the cable management tray, unlatch the swing arms and lift the base of the tray slightly upward before allowing
it to swing downwards. This completes the installation of the cable management tray. To gain improved access to the
hook-and-loop straps on the cable guides, refer to
management bracket on each MIO/UMIO card before you can route and secure network cables. For additional information,
refer to Installing Cable Management Brackets, on page
ASR 5500 Installation Guide
158
2 Swing arm
4 Post
Removing Cable Guides, on page
160.
Cable Management System Installation
159. You must install the cable