Door Reversal - Electrolux t4130 Service Manual

Door reversal

The door reversal illustrated below is on a
lefthinged door .
Reversing the door
• Disconnect the power to the dryer.
On the dryer
• Loosen the hinge mounting and push it down
to allow the door to be lifted off . Unscrew the
hinge mounting, fig. 1.
Note! Hold the door securely while loosening
the screws .
• Unscrew the cover screws at the opposite side
and loosely attach the hinge mounting . Screw
in the cover screws where the hinge was
previously mounted .
• Lay the door on a non-abrasive base, fig. 2.
• Remove the door handle. (3 Screws).
• Remove all screws (12 pcs.) from the edges.
• Remove the upper and lower pivots.
• Release the locking plates by loosening the
barb with a screwdriver .
• Lift off the back panel. Press the locking plates
out, swap them over and press into position .
• Turn the back panel 180° (half a turn).
• Assemble the door. Tighten the screws along
the edges . Fit the upper and lower pivots .
• Mount the door handle at the top.
• Mount the door on the dryer in the opposite
order as describe above .
Test the door
• Check that the door pin (A) is aligned with the
microswitch aperture, fig. 3.
• Reconnect the power to the dryer.
• Check that the tumble dryer stops when the
door is opened .
56
Cabinet, door reversal
1
2
Locking plates
3
A
Service
manual
Pivots