Service
manual
Connection to network/Central Panel
Fig . 1+2 . If several dryers are to be connected to a network/Central Panel a bushing for cables
are installed . See the installation manual enclosed the dryer .
1 . Disconnect the power .
2 . Remove the top plate .
3 . Drill a hole which is suitable for the bushing dimension . The dimension is depending
on the cable thickness, fig . 1 .
4 . Insert the bushing and pull the cable through the bushing and connect the cable to the
connection terminal, fig . 2 .
5 . The cable can now be installed .
6 . After installing mount the top plate again .
1
Drilling hole for Network connections
and External control
Controls
2
Terminal connection for Network and
External control
31