Electrolux t4130 Service Manual page 52

Description:
The drum is suspended at the back in a
bearing mounted in the rear plate .
At the front the drum rests on two bearing
rollers . See the section "Diassembling the
dryer" .
Replacement:
Replacement of rear bearing (bearing
housing) can be done without disassembling
the tumble dryer, fig . 1 .
Standard dryer .
1 . Dismount the heat shield .
2 . Unscrew the back cover A .
3 . Loosen the drive belt on the drum from
the motor .
4 . Unscrew the three screws B and the
nut on drum shaft and take out the
bearing and replace it with the new
bearing .
Condensate dryer
1 . Dismount the heat shield, fig . 2 .
2 . Dismount the plastic cover and unplug the
plug to the fan motor .
3 . Loosen the drive belt on the drum from
the motor .
4 . Unscrew the three screws B and the
nut on drum shaft and take out the
bearing and replace it with the new
bearing, fig . 1 .
52
Drum with bearing
1
B
A
2
Service
manual