Door Reversal - Electrolux T4130 Installation Manual

10

Door reversal

3. Unscrew the
cover screws at
the opposite
side and loosely
mount the hinge
mounting.
Screw in the
cover screws
where the hinge
was previously
mounted.
7. Mount the handle at the opposite side where the
plugs used to be.
8. Insert the plugs where the handle used to be.
9.­ Remove­the­bottom­pivot­to­the­other­side.
10. Release­the­locking­plates­by­loosening­the­barb­­
with a screwdriver.
11. Press out the locking plates, swap them over and
press into position.
Setup
1. Disconnect the power supply to the dryer.
2. Loosen the hinge mounting and push it down to
allow the door to be lifted off. Unscrew the hinge
mounting.
NB! Hold the door securely while loosening the
screws.
W00181
W00180
Upper pivot
4.­ Remove­the­three­black­plugs­at­the­top­of­the­­
door.
5. Dismount the handle by loosening the three screws.
6.­ Remove­the­pivot­at­the­top­to­the­other­side.
W00182
12. Mount the door. Push the hinge mounting
13. Test the door (use washers to adjust the hinge if
A
14. Connect the power to the dryer. Finally, check
W00186
TOP
TOP
W00184
upwards and tighten the screws.
necessary). Check that door pin (A) is aligned
with the microswitch aperture.
that the dryer stops when the door is opened.
Lower pivot
W00183
W00185