Care And Cleaning - Catler ES 4011 Instructions For Use Manual

CARE AND CLEANING

Before cleaning, ensure the selector control
is in the "STANDBY" position and press the
"POWER" button 'Off ' . Switch off at the power
outlet, then unplug the power cord and allow
the unit cooling.
Cleaning the steam wand and frothing
attachment
The steam wand and froth enhancer should
always be cleaned after frothing milk. Do
not leave the steam wand in the milk. This
ensures the Steam Wand is kept free of milk
deposits. Failure to do this may result in milk
being sucked back into the boiler heating
system.
Remove the froth enhancer and rinse under
warm tap water.
Wipe the steam wand with a damp cloth,
and then with the steam wand directed back
into the drip tray, briefl y set the selector
control to the position. This will clear any
remaining milk from inside the steam wand.
If the steam wand becomes blocked, wait
for the machine to cool before using the
cleaning tool to unblock the opening.
If the steam wand continues to be blocked,
the tip of the steam wand can be removed
by using the spanner in the middle of the
cleaning tool.
Soak the tip in hot water before using the
pin on the cleaning tool to unblock. Replace
the tip back onto the steam wand and secure
with the cleaning tool.
DO NOT USE a scourer or abrasive cleaner to
clean steam wand or housing.
Attention! Cleaning tool pin is very sharp.
NOTE
NOTE
16
CARE AND CLEANING