- Clean any excess ground coff ee from the
rim of the fi lter holder to ensure a proper
fi t into the group head.
Priming the group head
Before placing the fi lter holder into
position, it is recommended to run a short
fl ow of water through the group head.
Place a container or empty cup under the
group head, or allow water to fl ow straight
into the drip tray.
With the fi lter holder removed, prime
the group head by turning the
selector control to the
approximately 5 – 10 seconds and then
turn the selector control back to its
position. A pumping noise will be heard
during this operation, and water will run
through the group head.
Inserting the fi lter holder
Place the fi lter holder underneath the group
head so that the handle is aligned with the
„INSERT" graphic. Insert the fi lter holder up
into the group head and rotate the handle
to the right until resistance is felt or until it
can no longer be rotated. This will be at an
approximate 90° angle to the machine in
„LOCK" position.
position for
Brewing coff ee
Ensure the selector control is in the
Press the POWER button. The POWER
As soon as the red heating light turns off ,
Ensure the drip tray and fi lter holder are in
Place one or two pre-heated cups beneath
„STANDBY" position and plug the power
cord into a 230/240V power outlet and
switch on.
button surround will illuminate. The
red heating light will turn off when
the machine has reached the correct
temperature.
the machine is heated up.
place.
the fi lter holder outlet.
OPERATING YOUR ESPRESSO MACHINE ES 4011
10