Care And Cleaning - Catler 400 series Instructions For Use Manual

CARE AND CLEANING

Before cleaning, ensure the machine has
been turned off . Switch off at the power
outlet, unplug the power cord and allow the
machine to cool.
Cleaning the steam wand and froth
enhancer
• The Steam Wand and Froth Enhancer
should always be cleaned immediately
after frothing milk. Never leave Steam
Wand immersed in milk. This ensures the
Steam Wand is kept free of milk deposits.
Failure to do this may result in milk being
sucked back into the boiler heating
system.
• Remove the Froth Enhancer and rinse
under warm tap water (Fig 10).
• Wipe the steam wand with a damp cloth.
If the steam wand becomes blocked, use
the pin on the Cleaning Tool to clear the
opening. If the Steam Wand is not wiped
with a damp cloth immediately after use
milk deposits will bake onto the surface
and become harder to remove. If this
occurs it is recommended to soak the
Steam Wand before wiping with a damp
cloth.
DO NOT USE a scourer or abrasive cleaner to
clean Steam Wand or housing.
If the Steam Wand remains blocked, the tip
of the Steam Wand can be removed by using
the spanner in the middle of the Cleaning
Tool (Fig 12). Soak the tip in hot water
before using the pin on the Cleaning Tool to
unblock (Fig 13).
12
13
14
Replace the tip back onto the Steam Wand
and secure with the Cleaning Tool.
Cleaning the fi lters, fi lter holder and
brewing head
• The stainless fi lters and fi lter holder
should be rinsed under running water
NOTE
directly after use to remove all coff ee
particles. Should the fi ne holes in the
fi lters become blocked, the fi ne pin on
the Cleaning Tool can be used to clear
the holes (Fig 14).
• The brewing head should be wiped with
a damp cloth to remove any residual
coff ee grounds.
• It is advisable to periodically run water
through the machine with the fi lter
holder in place, but without any coff ee to
clean out any residual coff ee grounds.
14
CARE AND CLEANING