Setting A Basic Parameter - Toshiba VF-PS1 Instruction Manual

4.2 Setting a basic parameter

When Quick mode is selected using the EASY key function, skip step 1. Go straight to step 2.
1. Select/confirm "Basic parameters" using the control dial.
The Basic Parameters window appears.
Functions of function keys
: Goes to the Top View Mode.
F1
: Displays the previous window.
F2
: Displays the next window.
F3
2. Select/confirm the parameter you want to change, using the control dial.
(Ex. Select/confirm "Command input mode" and "Base frequency 1.")
4
The Parameter Setting window appears.
If the selected parameter is changed by selecting a
menu item, the menu item selected is highlighted
and marked with a checkmark.
Functions of function keys
F2
: Displays the previous window.
: Displays the next window.
F3
If the selected parameter is changed by specifying a
value, the value specified is displayed. In addition,
the minimum allowable value (min) and the maximum
allowable value (max) are displayed at the bottom of the
window.
Functions of function keys
The functions keys allow you to select the position or decimal place
of each figure (operation frequency) you want to increment or
decrement with the control dial.
F1
: Selects the position of 1000 times of minimum setting unit.
F2 : Selects the position of 100 times of minimum setting unit.
F3
: Selects the position of 10 times of minimum setting unit.
F4 : Selects the position of minimum setting unit (In this case, 0.1).
AU1
AU2
AU4
CMOd
FMOd
Top
F1
• If the setting selected is
changed by selecting a menu
item
0 :Terminal
1 :Panel / LCD-option
2 :RS485-2wire
3 :RS485-3wire
• If the setting selected is
changed by specifying a
value
min=25.0
×1000
F1
D-2
E6581429
Parameter Setup Mode
Basic Parameters
:Automatic acc/dec
:Automatic torque boost
:Automatic function set
:Command input mode
:Frequency input mode 1
F2 F3
Basic Parameters
CMOd
Command input mode
F2 F3
Basic Parameters
vL
Base frequency 1
60.0
Hz
max=500.0
×100 ×10 ×1
F2 F3 F4
∨
口