The Details Of The Parameter Setting; Network Error Detection (C100 - C103) - Toshiba TOSVERT VF-MB1 Function Manual

3.3. The details of the parameter setting

Network error detection (c100 - c103)

3.3.1.
▼Display of trip information
err8 (Optional unit fault 1: 0x001B): Network error stop
▼Related parameter
Title Function
Communication error
c100
detection delay time
Inverter operation at the
c101
communications loss action
Preset speed operation
c102
selection
Communication time-out
c103
condition selection
*The behavior of the drive in the system that connected two (or more) drive by the
EtherCAT network.
When the cable of OUT of drive at the first position is removed,
the drive at the first position did not detect communication abnormality.
The drive at the second position detected communication abnormality.
The master station was able to send data (LFRD) to drive at the fist position.
However, information (ETA and RFRD) on the drive was not able to be read.
It seems that TwinCAT's problem.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Setting range
The waiting time from when a network error occurs
can be adjusted. If a network error continues past
the time set in c100, it is recognized as a
communication error and the operation of the drive
follows the setting of c101.
When normal communication returns during the
setting time, a communication error is not displayed
0.0-100.0 sec
and operation is continued.
*The time unit time-out operates =
EtherCAT watchdog + c100 (communication
error detection delay time) [0.1s]
The operation of the drive when the communication
0-5
fault occurs can be specified.
The operation frequency of the drive when the
communication fault occurs can be specified. (Only
0-15
when c101 is set to 5)
Select the communication time-out condition.
0-2
- 12 -
E6581818
Description