Table of Contents
Advertisement
3
Gateway Mode
LAN
The Pocket VoIP Gateway must have a valid IP address for management using a
web browser and to support other features. The unit has a default IP address of
192.168.7.1. You can use this IP address or assign another address that is
compatible with your existing local network. The unit can also be enabled as a
Dynamic Host Configuration Protocol (DHCP) server to allocate IP addresses to
local PCs and wireless clients. The unit supports up to 32 local clients.
LAN Settings
The Pocket VoIP Gateway includes a DHCP server that can assign temporary IP
addresses to any attached host requesting the service. Addresses are assigned to
clients from a common address pool configured on the unit. Configure an address
pool by specifying start and end IP addresses. Be sure not to include the unit's IP
address in the address pool range.
• IP Address – The IP address of the unit. Valid IP addresses consist of four decimal
numbers, 0 to 255, separated by periods.The default setting is 192.168.7.1.
• Subnet Mask – Indicates the local subnet mask is fixed as 255.255.255.0.
• The Gateway acts as DHCP Server – Check this box to enable the DHCP server.
- IP Pool Starting/Ending Address – Specifies the start and end IP address of a
range that the DHCP server can allocate to DHCP clients. You can specify a
single address or an address range. Note that the address pool range is always
in the same subnet as the unit's IP setting.
- Lease Time – Selects a time limit for the use of an IP address form the IP pool.
When the time limit expires, the client has to request a new IP address.
3-6
Figure 3-5. Gateway Mode LAN Setup
Advertisement
Table of Contents
