Table of Contents
Advertisement
Chapter 2: Using the Setup Wizard
The Pocket VoIP Gateway can automatically configure its operating mode for use as
a gateway or wireless client. However, it still requires some manual configuration for
other modes, its WAN port connection, wireless settings, and VoIP functions. The
Setup Wizard takes you through the basic configuration steps for the current
operating mode.
Note: The Setup Wizard steps depend on the current operating mode. You should first
make sure the Pocket VoIP Gateway starts in the mode that you want to use.
Launching the Setup Wizard – To perform basic configuration, click Start with
Setup Wizard on the main menu.
The following sections detail the necessary steps in configuring the Pocket VoIP
Gateway in each of its operating modes.
Gateway
When configuring the unit to operate as a gateway, you will need to proceed through
the following four steps:
1.
Settings – The Settings page takes you through the wireless SSID (Service Set
Identifier) configuration.
Figure 2-4. Starting the Setup Wizard
2-1
Advertisement
Table of Contents
