Table of Contents
Advertisement
Gateway Mode:
• Status – Display system information.
• System – Configure the mode and other settings.
• WAN – Configure WAN port connection settings.
• LAN – Configure LAN settings.
• Wireless – Configure wireless access settings.
• VoIP – Configure VoIP settings.
• NAT – Configure Network Address Translation settings.
• Firewall – Configure firewall settings.
Access Point Mode:
• Status – Display system information.
• System – Configure the mode and other settings.
• Wireless – Configure wireless access settings.
• VoIP – Configure VoIP settings.
Wireless Client Mode:
• System – Configure the mode and other settings.
• VoIP – Configure VoIP settings.
Manually Setting the Operating Mode
To set an operating mode for the Pocket VoIP Gateway that is not dependent on the
WAN port connection, you must access the Advanced Configuration, System, Mode
Configuration page.
Note: Access Point mode can only be set through manual configuration.
Follow these steps:
1.
Log into the web interface.
2.
Click Start with Advanced Setup.
3.
From the menu (in any mode), click System, then Mode Config.
4.
Set the Mode Selection to Manual, then select the operating mode you want to
use.
5.
Click Apply to confirm the setting and restart the unit.
Note: Changing the Pocket VoIP Gateway's operating mode always resets the unit.
Manually Setting the Operating Mode
see page 9-1
see page 6-1
see page 3-3
see page 3-6
see page 7-1
see page 8-1
see page 3-7
see page 3-10
see page 9-1
see page 6-1
see page 7-1
see page 8-1
see page 4-2
see page 8-1
1
1-3
Advertisement
Table of Contents
