Table of Contents
Advertisement
3-2. RS-232 Settings
Interface and Requirements
The RS-232 Commands use only ASCII characters which can be entered
using a typical terminal emulator like Windows HyperTerminal with
the following setting:
Note that each input character will be echoed on the terminal by MCU and
there is no need to set the local echo "ON" with the terminal setting.
When using
baud rate
When using
use baud rate
Bits per second:
Data bits:
8
Parity:
None
Stop bits:
1
Flow control:
"Delta Mode"
"115200"
to set and communicate.
"Normal Mode"
"19200"
to set and communicate.
19200 (Delta Mode: 115200)
None
to operate projector, please use
to operate projector, please
10 of 73
Advertisement
Table of Contents
