Table of Contents
Advertisement
B. Use the RJ-45 comment to Retrieve Error Code
A. Connect the AC power of the projector and have the projector in standby mode.
B. Connect the RJ-45 cable between the projector and the PC. And make sure that the two LEDs
of the RJ-45 module are lit after connecting the RJ-45 cable between the PC and the projector.
If the LEDs are not lit, please send the RS command "eco.net.pow = 0" on the terminal to turn
on the RJ-45 module.
C. Properly setup the IP for the PC and make sure that the PC and the projector are in the same
subnet. For example, the default IP of the projector is 192.168.0.100. So the IP of the PC
should be set as
192.168.0.99
for example.
D. Key in the projector IP on the web browser (the recommended web browser is IE 6.0 or later
version, the default IP is 192.168.0.100) to see the embedded webpage. The IP can be
accessed via the RS command "op net.ipaddr ?" with a terminal program.
14 of 73
Advertisement
Table of Contents
