Honeywell 10288 Manual page 16

29. (Optional) To install the fan without the light kit:
Unscrew the hex nut and washer from the threaded
rod in the switch housing to remove the light kit and
wiring (Fig. 29).
30. Remove the three fitter plate screws from the fitter
plate. Then, align the holes in the switch housing
with holes in the fitter plate. Re-insert the previously
removed fitter plate screws. Use a Phillips
screwdriver to secure all screws. Plug the hole in the
bottom of the switch housing with the plug button
(Fig. 30).
Plug Button Fitter Plate
Screw
31. Attach the pull chain extension(s) to the fan and
light pull chains (if applicable) (Fig. 31).
Fan Pull Chain
Assembly is complete. Turn on the circuit breakers and
the wall switch to the fan supply lead wires.
LIGHT KIT INSTALLATION
Light Pull Chain
Fig. 29
Fig. 30
Switch
Housing
Fig. 31
16
Hex Nut
Washer
Switch
Housing
Light Kit
Fitter Plate
Plug Button
Fan
Pull Chain
Pull Chain
Screw
Light