Honeywell 10288 Manual page 15

26. Install the candelabra-base A15 bulbs (Fig. 26).
27. Feed the fan pull chain from the switch housing
through the off-center hole in the glass bowl. Then,
feed the pull chain from the light kit through the
center hole in the glass bowl, rubber washer and
hex nut (Fig. 27).
28. Lift the glass bowl and rubber washer over the
threaded rod. Screw the hex nut onto the threaded
rod to secure the glass bowl. Feed the pull chains
through the appropriate holes in the finial cap. Lift
the finial cap up until it is flush with the glass bowl
and secure with the finial (Fig. 28).
Proceed to step 31.
LIGHT KIT INSTALLATION
15 15
Fig. 26
Fig. 27
Switch Housing
Rubber Washer
Hex Nut
Fig. 28
Rubber
Washer
Threaded Rod
Hex Nut
Finial Cap
Finial
Bulb