Page 1
Instruction manual MODEL NO: SV400G-IM Spagna Vetro Range Hood Burnaby, BC, Canada www.KitchenHoods.ca Tel:604 430 5252...
Page 2
Warning Keep your children out from using the range hood. Your range hood is for domestic use only, not suitable for any commercial usage. Any installation work must be carried out by a qualified electrician or competent person. ...
Page 3
Installation 1. The range hoods should be placed at a distance of 26-30 inches from the cooking surface for best effect. See Pic 1. 2. For safety, the ceiling should be able to carry load of a 200 pounds , Drill a hole with dia 8” in the ceiling as shown on Pic 3.
Page 4
Pic 4 Pic 5 Pic 6 Cleaning and Maintenance Change and clean the anti-grease filters Tear down your range hood as per the approach shown on Pic 6. You can clean the filter as below: 1. Soak them about 3 minutes in hot water (40-50 degrees) with a grease-loosening detergent then brush it gently with a soft brush.
Page 5
2. It can be put into a dishwasher with detergent, set the temperature at around 60 degrees. Please do not use abrasive detergent because it will damage the hood. Make sure that the hood is switch off before cleaning. Carbon filter installation (See Pic 7) ...
Page 6
1. Plug the hood; LCD will display 24-hour system with blue backlight. Backlight will be extinguished after 30 seconds without any operation. 2. Press “ ” button once; lights will be on and LCD will show “ ”. Press “ ”...
Page 7
Continue pressing “ ” button; it will display from 13;14… until 23. When LCD shows 23; it doesn’t work by pressing “ ” button. Press “ ” button once; the number reduces by 01. When LCD shows 00; it doesn’t work by pressing “ ”...
Page 8
LCD display will only show 24-hour system with blue backlight. After 30 seconds without operation; blue backlight will disappear. But please note the Lamp is not under control of delay timer. Next time; if you want to use delay timer function and you press “ ” button without any change on time.
Need help?
Do you have a question about the SV400G-IM and is the answer not in the manual?
Questions and answers