Endura AZ30 series integral probe and remote transmitter
Combustion oxygen monitor
6.4.9 Device Info
Menu
Device Info
Exit
Parameter
Serial Number
Date of Manufacture
Date of Last Cal.
Probe Type
AZ20 & Integral Tx
AZ20 & Remote Tx
AZ25 & Remote Tx
AZ30 & Integral Tx
AZ30 & Remote Tx
AZ35 & Remote Tx
Table 6.14 Device Info
COI/AZ30E–EN Rev. D
Identifies the transmitter's serial number, transmitter's date of
9
manufacture, the last oxygen calibration date, the probe type,
the transmitter options card (if fitted), AutoCal hardware (if
fitted) and main board and software version numbers.
Note. Parameters in this menu are read-only.
Select
Comment / [Range]
The serial number of the transmitter.
The time and date the transmitter was manufactured.
The date of the last oxygen calibration.
Note. The date is updated automatically against the
date set in the transmitter.
The probe type used with the transmitter.
6 Programming
Default
Factory-set
Factory-set
N / A
Factory
pre-set for
ordered
system
67