Integral Transmitter - Probe Connections - ABB Endura AZ30 series Programming Manual

Endura AZ30 series integral probe and remote transmitter
Combustion oxygen monitor
5.4.3 Integral Transmitter – Probe Connections
Caution. Connections from the transmitter to the probe head and from the probe head to the probe are
made at the factory. This section is for information only.
Probe Connections
(behind probe lid)
 265 V AC
Numbered Connections
From Transmitter
Probe Cable Standard Connections
to 9-way Terminal Block
Heater (Blue)
1
1
Heater (Brown)
2
2
3 Screen*
3
4 Thermocouple – (White)
4
5 Thermocouple + (Green)
5
6
Cell – (Black)
6
7
Cell + (Red)
7
8
ACJC (Grey)
8
9
ACJC (Violet)
9
*Screens must be connected to the terminal in the remote terminal housing (not directly to earth).
**6-Way terminal block fitted only on AutoCal option.
Fig. 5.9 Probe Connections at Integral Transmitter
COI/AZ30E–EN Rev. D
Probe Cable AutoCal Connections
to 6-way Terminal Block**
Solenoid Valve 2 (White / Blue)
Solenoid Valve COM (White / Red)
Solenoid Valve 1 (White / Green)
Pressure Switch 1 (White / Orange)
Pressure Switch COM (White / Black)
Pressure Switch 2 (White / Yellow)
5 Electrical Installation
Numbered Connections
From Transmitter
15
15
14
14
13
13
12 12
11
11
10
10
29