Remote Transmitter; Remote Transmitter - Power And Output Signal Connections - ABB Endura AZ30 series Programming Manual

Endura AZ30 series integral probe and remote transmitter
Combustion oxygen monitor

5.3 Remote Transmitter

5.3.1 Remote Transmitter – Power and Output Signal Connections
Warning.

The transmitter must be earthed.

Isolate the incoming mains power supply cable before making connections at the transmitter.
Referring to Fig. 5.2, page 21:
1. Unscrew and remove the transmitter rear cover
necessary).
2. Access power supply terminals, by unclipping latch
3. Feed the incoming AC power supply cable through cable gland
4. At terminal block
terminals.
5. Connect the incoming AC power supply earth wire to internal earth connection
6. Close the hinged power supply cover
7. Feed the signal cable(s) through cable gland(s)
current output and option terminals as required.
8. Refit the transmitter rear cover
20
E
make connections to the AC power supply live (brown) and neutral (blue)
C
A
and tighten it hand-tight.
A
(a lever can be used across the flats if
B
and lifting hinged power supply cover
.
G
and make connections to the relay output(s),
5 Electrical Installation
D
.
F
.
COI/AZ30E–EN Rev. D
C
.