Cyclic Data; Parameter Dump - ABB Endura AZ30 series Programming Manual

Endura AZ30 series integral probe and remote transmitter
Combustion oxygen monitor

10.5 Cyclic Data

Cyclic data can be saved and output to a spreadsheet or as text. The update rate and data groups enabled
for output are selected at the Communication / Cyclic Output menu.
To output cyclic data:
1. Launch a terminal application.
2. Configure the terminal application to communicate with the COM port specified previously in the
Service Port Switch.
3. To start the output routine, press 'P' on the PC keyboard (press 'S' to stop).
A header row is created and enabled data is output at the interval set.
4. To output the data to a spreadsheet:
a. use the capture capability to save a text (.txt) file
b. open the .txt file into Excel
c. at the Excel Text Import Wizard, select the file type as Delimited
Data is labelled and formatted automatically for display and analysis.

10.6 Parameter Dump

The parameter dump option enables two types of information to be downloaded:

Configuration settings

Diagnostic Log and Signals View values
To run a Configuration settings dump:
1. Launch a terminal application.
2. Configure the terminal application to communicate with the COM port specified previously in the
Service Port Switch – see Section 10.4, page 97.
3. Press 'C' on the PC keyboard to start the output routine.
4. To output the data to a spreadsheet:
a. use the capture capability to save a text (.txt) file
b. open the .txt file into Excel
c. at the Excel Text Import Wizard, select the file type as Delimited
Data is labelled and formatted automatically for display and analysis.
98
10 Remote Computer Connection
COI/AZ30E–EN Rev. D