Remote Control; Setting The Clock - Goodmans GMC1042MP3 Instruction Manual

Remote Control

The remote control requires 1 x 3V Lithium
Battery, (CR2025).
Battery Installation
1. Press the small clip down a little as shown
in the first picture then slide the battery
holder out and remove.
2. Refer to polarity (+ or -) markings on the
battery holder and insert a new battery.
3. Replace the battery holder
Note: The remote control will cease to
function when the battery becomes
weak.
Operating the remote control
Point the remote control at the front of the CD
micro system, to operate. The IR sensor is
located below the LCD display.
The remote control will work up to 7m away from
the IR sensor.
Do not block the path of the beam from the
remote control to the unit. Dark walls, direct
sunlight or very bright light will reduce the
sensitivity of the IR sensor

Setting the Clock

The clock can be set by using the buttons on
the front of the unit or the remote control.
Setting the Clock
1. Connect the main plug to a main supply
scoket.
2. Press and hold the PROG./MEMORY
button.
3. Press TONE button, the display will show
the time with the hours flashing, use
either of the SKIP buttons to select the
hours and
button, the hours stops flashing.
4. The display will show the time with the
minutes flashing, Use either of the SKIP
buttons to select the minutes and press
PROG./MEMORY button, the minutes
stops flashing.
The clock is now set.
7
press PROG./MEMORY