Track Selection; Playing A Cd - Goodmans GMC1042MP3 Instruction Manual

CD player
Operation
At the front of the CD micro system, or using the
remote control, press POWER, to switch the CD
micro system on. The LCD display will light up.
Push the CD / MP3 button to switch to CD mode.
The display will initially flash zeros then show
'no dISC'.
Only use CDs that bear
the CD logo.
Loading and Unloading CDs
1. Press the PUSH OPEN button on the CD
door to open the CD compartment.
Note: If using the CD micro system for the
first time, remove the protective sheet from
inside the compartment, before use.
2. Remove the CD from its case, place
carefully into disc compartment over the
centre spindle and lock in place, with the
label side up.
3. Press the OPEN/CLOSE button to close
the CD door. The display will show the
total number of tracks and the total playing
time. The CD door can be opened at any
time.
First press either STOP on the remote
control or STOP on the unit, then press
the OPEN/CLOSE button.
Please Note:
- Do not place foreign objects into the CD
compartment, this may damage the
mechanism.
- Always keep the CD door shut, to prevent
dust or dirt from getting into CD
mechanism.
- Never place more than one CD into the
CD compartment at any time.
- After CD door is closed, CD information
may not appear on the LCD display, this
means the CD cannot be read by the CD
mechanism. Refer to the 'Care and
maintenance' section.

Playing a CD

On CD micro system, or remote control:
1. Press the play/pause button#$. The
display will show the track number and
the elapsed playing time.
2. To pause playback, press the play/
pause button#$. The elapsed time
will hold.
3. To resume playback press play/pause
#$again.
4. To stop playback, press either STOP
on the remote control or STOP on the
unit.

Track Selection

Using the remote control:
1. Press either the !" buttons to select
the desired track number.
2. Press play/pause, #$ to start playing.
Using the unit controls:
1. Press either of the SKIP/TUNING
buttons to select the desired track
number.
2. Press PLAY/PAUSE, to start playing.
Track Selection During Play Using
the remote control:
1. During play, press either of the !"
buttons to select the desired track
number. The selected track will
automatically start to play.
Using the unit controls:
1. During play, press either of the
SKIP/TUNING buttons to select the
desired track number. The selected
track will automatically start to play.
11