Ricoh pentax KP Operating Manual page 55

6
Press 0 fully again.
Movie recording stops.
u Caution
• When recording a movie with sound, camera operation
sounds are also recorded. When [AF Mode] of [AF with Live
View] in the C1 menu is set to y, the focus operation
sounds are recorded. Adjusting the sound volume in
[Recording Sound Level] of the C1 menu, or using an
external microphone can reduce the operation sounds to be
recorded. When [Recording Sound Level] is set to [Manual],
the sound volume can be set from 0 to 20.
• When recording a movie with an image processing function
such as Digital Filter applied, the movie file may be saved with
some frames omitted.
• If the internal temperature of the camera becomes high
during recording, recording may be terminated.
• When a retractable lens is attached, recording stops if the
lens is retracted during recording and an error message is
displayed.
t Memo
• You can record a movie continuously up to 4 GB or
approximately 25 minutes. When the memory card is full,
recording stops.
• You can change the settings for movie recording in the C
menus. (p.29)
• By default, autofocus is not performed when 0 is
pressed halfway during movie recording. If a compatible lens
is attached to the camera, you can select y in [AF Mode]
of [AF with Live View] in the C1 menu and continuously
autofocus even during movie recording. (p.62) When [AF
Mode] is set to y, the f button operation varies as
follows depending on the setting assigned to f in [Button
Customization] of the C2 menu. (p.102)
[Button Customization]
setting
Enable AF1, Pressing f performs autofocus
Enable AF2 based on the [AF Mode] setting.
Pressing f stops autofocus
Cancel AF and pressing f again restarts
autofocus.
Autofocus operation when f
is pressed
Using a Microphone or Cable Release
You can connect a commercially
available stereo microphone to
the microphone/cable release
terminal on the camera. Using an
external microphone can also help
to reduce the possibility of
recording camera operation
sounds.
The following specifications are
recommended for external microphones. (A monaural
microphone cannot be used with this camera.)
Plug Stereo mini plug (ø3.5 mm)
Format Stereo electret condenser
Plug-in Power Method (operating
Power
voltage of 2.0 V or lower)
Impedance 2.2 kΩ
You can also connect the optional Cable Switch CS-310 to
the microphone/cable release terminal on the camera. When
the cable release is connected, sounds are recorded with the
built-in microphone.
You can set the device to connect
in [External Input Devices] of the
D3 menu. Normally, you do not
need to change the default setting
([Auto Select]).
u Caution
• Do not connect a microphone or other device outside the
recommended specifications to the microphone/cable
release terminal. Also, do not use an external microphone
with a 3-meter or longer cable. Doing so may cause the
camera to malfunction.
• If an external microphone is used when recording a movie
with the Wi-Fi™ function enabled, radio noise may be
recorded depending on the compatibility with the microphone.
Microphone/cable
release terminal
External Input Devices External Input Devices
External Input Devices External Input Devices
Automatically detects input Automatically detects input
device and switches between device and switches between
cable release and microphone cable release and microphone
Cancel Cancel OK OK
53
3