Setting The Timer Duration Time; Significance Of I/O Line Status; Line Status For Input Lines - Basler acA2040-55 User Manual

AW00123409000

5.12.6.3 Setting the Timer Duration Time

You can set the Timer 1 duration by setting the TimerDuration parameter. The units for setting this
parameter are µs and the value can be set in increments of 1 µs.
To set the duration for Timer 1:
1. Use the Timer Selector to select Timer 1.
2. Set the value of the TimerDuration parameter.
You can set the TimerSelector and the TimerDuration parameter value from within your application
software by using the Basler pylon API. The following code snippet illustrates using the API to set
the selector and the parameter value:
camera.TimerSelector.SetValue(TimerSelector_Timer1);
camera.TimerDuration.SetValue(10.0);
You can also use the Basler pylon Viewer application to easily set the parameters.
For more information about the pylon API and the pylon Viewer, see Section 3.1 on

5.13 Significance of I/O Line Status

5.13.1 Line Status for Input Lines

This section informs about the relation between input line status and certain external conditions.
The opto-isolated and the GPIO input lines are considered.
The line status information depends, among others, on whether the input line inverter is disabled or
enabled (Section 5.11.3 on
Make sure the ground for opto-isolated I/O and the ground of the power supply for the opto-isolated
input line are connected to the same ground.
For applicable pins, see
and Figure 44.
Basler ace USB 3.0
page 94).
Table 20 on page 68, and for line schematics, see
Physical Interface
page 61.
Figure 40, Figure 43,
103